Retraction right at start · Issue #9373 · Ultimaker/Cura · GitHub

Application Version Arachne_no_build_number_in_About Platform Mint 20.1 Printer Custom Reproduction steps Slice Save Open output GCode Actual results ;; LOOK NEAR THE BOTTOM OF THIS START CODE FOR THE ISSUE//QUESTION ;FLAVOR:Marlin ;TIME

4.5.0] Firmware Retract Missing? · Issue #7295 · Ultimaker/Cura · GitHub

Camera view in UI is locked. Can´t zoom, rotate, pan nothing. · Issue #14097 · Ultimaker/Cura · GitHub

Arrange without rotate · Issue #9382 · Ultimaker/Cura · GitHub

Allow changing retraction speed/length/prime speed in ChangeAtZ · Issue #5321 · Ultimaker/Cura · GitHub

Cura 2.3.1-0 Enable Retraction Causes Massive Retraction at the End of Print · Issue #1263 · Ultimaker/Cura · GitHub

Ultimaker Cura 3.3 Linux ARM version crashes on RPI 4 · Issue #8384 · Ultimaker/Cura · GitHub

Unnecessary retractions with Combing mode Off · Issue #4308 · Ultimaker/ Cura · GitHub

Unwanted coasting on sharp corner due to reduced flow · Issue #8046 · Ultimaker/Cura · GitHub

Spiralize Outer Contour IGNORES all retraction · Issue #12498 · Ultimaker/ Cura · GitHub

Cura 3.1 MacOs 10.13 Unable to slice when retraction is enabled · Issue #3130 · Ultimaker/Cura · GitHub