BUG] Additional retract when linear advance is on. · Issue #19982 · MarlinFirmware/Marlin · GitHub

i have problem on 0.2 mm nozzle and 0.1 mm layer height. Marlin.zip Marlin 2.0.7.1 And I tried to fix this problem, which worked properly by deleting the original retract, but then it crashed due to other retractions. the slicer is cura

QUESTION] LIN_ADVANCE 1.5 -- extruder rattles *a lot*. · Issue

LINEAR ADVANCE 2.0 · Issue #10812 · MarlinFirmware/Marlin · GitHub

BUG] [Bugfix 2.0.x] TMC2209 + Linear advance = Line stair for the

FR] Auto-retraction via Linear Advance · Issue #15005

QUESTION] LIN_ADVANCE 1.5 -- extruder rattles *a lot*. · Issue

Bug in Linear Advance 1.5, causes extruder motor to stop for

BUG] Rapid changes of acceleration break linear advance when using

BUG] Bulge on linear advance speed change · Issue #16880

QUESTION] LIN_ADVANCE 1.5 -- extruder rattles *a lot*. · Issue

BUG] JUNCTION_DEVIATION creates unexpected decelerations

BUG] Rapid changes of acceleration break linear advance when using

2.0] Linear Advance step generation issue causing motor noise

BUG] Bulge on linear advance speed change · Issue #16880