Hotend pauses on print for a few seconds after finish printing

Any one know how to change settings/gcod so that the hotend does not pause on the top layer after it finish printing? This leaves a dimple where it paused. Thanks!

Ender 3 v2 temperature drop - 3D Printing Stack Exchange

Stops Extruding Mid-Print (Tried everything I could think of) - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

What causes unexpected printer pause? - LulzBot TAZ - LulzBot

HOTEND THERMAL RUNAWAY ( drop temperature ) – Hardware, firmware and software help – Prusa3D Forum

Leaking hotend - multiple prints fail after about two hours, shorter prints are ok. Before this print I cleaned the hot end and it was spotless, put in a new steel nozzle

Creality Hot End Repair and Parts Guide for Ender 3, CR-10, and other Creality 3D printers — Creality Experts

Making Your 3D Printer Pause or Wait with G-Code in Marlin - 3D Print Gorilla

Filaflex vs 'All-metal' hotends - Recreus

Anatomy of a 3D Printer: How Does a 3D Printer Work?

Fighting and Winning against Heat Creep in 3D Printers — 3D-Fuel

🔥 The definitive guide to solving 3D printing problems by Bitfab - Bitfab