Prints stuck at layer 2 with Prusa Slicer

I'm having some issues with progress estimates and the displayed current layer does not go past 2. Prints fine. Running RepRapFirmware 3.1.1 but the issue was also present with 2.05 before upgrading Update: The total layer count on this specific print is

Continue a Failed 3d Print : 9 Steps (with Pictures) - Instructables

Prusa I3 Mk3

How to Avoid Layer Separation in Your 3D Prints

Incorrect support speed , seems to stuck at some low speed. · Issue #439 · supermerill/SuperSlicer · GitHub

Weird tool path in print, possible to edit? – Hardware, firmware and software help – Prusa3D Forum

Printer stuck in a corner – Assembly and first prints troubleshooting – Prusa3D Forum

Prusa 3D Printer – Raplab

3D-Print Guide 3D Prima - 3D-Printers and filaments

Support Interface layer stuck – PrusaSlicer – Prusa3D Forum

Stuck at preparing infill with only infill where needed enabled 1.41.2 · Issue #1696 · prusa3d/PrusaSlicer · GitHub