Nozzle problem : r/ender3

Just got a bl touch. But now the nozzle won't reach the bed : r/ender3

Nozzle temp error after upgrading to direct drive : r/ender3

Is this symptomatic of a clogged nozzle? : r/ender3

Just got a bl touch. But now the nozzle won't reach the bed : r/ender3

Ender 3 v2 - crooked nozzle : r/ender3

Nozzle broke off. What's the best way to proceed? : r/ender3

Help! Ender 3 wont heat up. When I try to pre heat the nozzle, a clicking sound pops up and then I get this error message. Running on marlin software @ 4.2.7

Should fan duct be lower than nozzle? Ender 3 s1 : r/ender3

Bed-level issue : r/ender3

Ender 3 issues : r/ender3

Surely replacing the nozzle would be easy. Unscrew, rescrew, right?” *15 minutes later* “I'm going to kill myself.” What am I doing wrong? The wrench fits! : r/ender3

Ender 3 seems to keep clogging : r/ender3

Bad warping issues when printing flat prints. : r/ender3